E
N
G
L
IS
H
53
By holding down the
h
key, you can quickly increase the time
value, up to reach the max. value allowed for this item. Vice
versa, by holding down the
i
key, you can quickly decrease
the time value down to reach
0.0
”.
In some circumstances, setting the value to 0 means that the
relevant function is disabled, in this case, ‘no’ will appear instead
of
0.0
”.
By pressing on
OK
you will confirm the displayed value and
you will return to the configuration menu.
Value menu setup
Value menus are similar to time menus; however, the setup value
can be any number.
By holding down
h
or
i
keys, the value will increase or
decrease slowly.
By pressing on
OK
you will confirm the displayed value and
you will return to the configuration menu.
10 - ACCESSING THE CONTROL
UNIT SETTINGS
1.
Press and hold the OK key until the display shows the menu
desired
2.
Release the
OK
key: the display will show the first item in the
sub-menu
-PrG
Programming the control unit (full menu)
-Cnt
Cycle counter
-SEt
Installation menù
-dEF
Loading the default parameters
m
WARNING: in case no operation is carried out for
more than one minute, the control unit exits from the
programming mode without saving any of your setups and
changes, which will get lost.
11 - QUICK CONFIGURATION
This paragraph concerns a quick procedure to set the control unit
and set it at work immediately.
We recommend following these instructions, in order to
check quickly the correct operation of control unit, motor
and accessories, and then changing the configuration in
case of any non-satisfactory parameter.
1.
Call up the default configuration: see paragraph “LOADING OF
DEFAULT PARAMETERS”
2.
Set items
StoP, Foto, CoS, FC.En
according to the safety
devices installed on the gate.
3.
Start the self-learning cycle: see paragraph “AUTOMATIC
LEARNING OF THE RUN LIMITS“
4.
Check that the automation work properly and if necessary
modify the configuration of the desired parameters.
For the position of the item menus inside the main menu and
for the options related to each item menu, refer to the
paragraph “CONFIGURATION OF THE CONTROL UNIT”.
Summary of Contents for VEGA-24V
