V2 VEGA-C 120V User Manual Download

Page: 36 / 148

8 - CONTROL UNIT

PD11 is provided with a display that, not only makes
programming simple, but also allows a continuous monitoring
of the input statuses; in addition, thanks to a menu structure,
the working schedule and the operation logic can be set easily.

In compliance with the European standards concerning
electrical safety and electromagnetic compatibility
(EN 60335-1, EN 50081-1 and EN 50082-1) it has been
equipped with the low voltage circuit total electric insulation
(motors included) from the network voltage.

Other characteristics:
• Automatic control for the null current relay switch.
• Power adjustment with wave shutting.
• Obstacle detection by means of monitoring start condenser

voltage.

• Automatic learning of the operation time.
• Specific entrances for end stops.
• Tests for safety devices (photocells, ribbons and triacs)

before each opening.

• Deactivation of safety inputs through the configuration

menu: no jumper is required for terminals concerning safety
devices that have not been installed, yet. You will only need
to disable this function from its relevant menu.

• Control unit programming can be locked through the optional

CL1+ key

WARNING: Installation of control unit and safety

devices must be carried out with power disconnected

8.1 - POWER SUPPLY

The control unit must be fed by a 230V 50Hz (120V - 50/60Hz
for the model PD11-120V) electric line, protected by a
differential magnetothermal switch complying with the law
provisions in force.

Connect power supply cables to terminals

and

of PD11

control unit

8.2 - COURTESY LIGHTS

Thanks to the output COURTESY LIGHT the control unit PD11
allows the connection of an electric appliance (e.g. courtesy
light or garden lights), controlled automatically or by means of
the special transmitter key.
The output COURTESY LIGHT is a simple N.O. contact with no
power supply.

Connect the cables to terminals

and

8.3 - WARNING LIGHT

Thanks to the WARNING LIGHT output, the PD11 central unit
allows you to monitor the state of the door in real time and the
kind of flashing signal indicates the four possible conditions:

STOP light off
IN PAUSE light always on
OPENING the light flashes slowly (2 Hz)
CLOSING the light flashes rapidly (4 Hz)

The output provides the connection of a 24V bulb. The
maximum charge shall be included in the 3W at the disposal
for the accessories.

Connect the cables to terminals

and

8.4 - PHOTOCELL

PD11 control unit supplies a 24VAC power supply to photocells
and it can perform a photocell operation test before starting
the door opening phase. Photocell power terminals are
protected by an electronic fuse that stops current in case of
overload.

The photocells are active only during the closing phase and, if
required, with standstill door. In case intervention, the control
unit immediately opens the door, not waiting for the release.

• Connect power supply cables of photocells transmitter

between terminals

and

of the control unit.

• Connect power supply cables of photocells receiver between

terminals

and

of the control unit.

• Connect receiver output between terminals

and

of the

control unit. Use outputs having normally closed contact.