E
N
G
L
IS
H
55
Auxiliary channel
This menu allows setting the operating of the relay of the lighting of the
courtesy lights by means of a remote control stored on the channel 4 of
the receiver MRx.
tiM
the relay is activated receiving the transmission of the
remote control; it is disabled after the time set for the
parameter t.LUC inside the menu LUCi
Mon
the relay is activated for all the length of the
transmission of the remote control. Releasing the key of
the remote control the relay is deactivated
biSt
the status of the relay changes at each transmission of
the remote control
Setting low voltage exit lights
This menu makes to possible to set the flashing exit function.
FLSh
flashing function (fixed frequency)
no
output not abled
WL
spy lamp function: it indicates in real time the state of the
barrier, the type of flash indicates the four possible conditions:
- BARRIER CLOSED the light is off
- BARRIER IN PAUSE the light is on fixed
PLEASE NOTE: the light remains off if the ENERGY SAVING
function is enabled and automatic closure is deactivated
- BARRIER IN OPENING the light blinks slowly (2Hz)
- BARRIER IN CLOSING the light blinks fast (4Hz)
Flashing lamp in pause
Normally the flashing lamp works alone during the barrier’s movement.
If this function is enabled, the flashing lamp works also during the
pause time (barrier opened with active automatic closing).
PLEASE NOTE: The flashing light remains off if the ENERGY
SAVING function is enabled and automatic closure is deactivated
The blinking led can either be the device connected to the output in low
voltage (setting up the FLSh parameter in the menu SPiA) or the device
connected to the output LUCI (setting up the CiCL parameter in the
menu LUCI).
Courtesy lights
This menu allows setting up the operation of the courtesy lights
automatically during the barrier’s opening cycle.
NOTE:
If the output is used to monitor a flashing lamp (with
internal intermittence) select the voice Cycle.
t.LUC
the relay becomes activated upon receiving of the START
command; choosing this option takes you to a submenu
that allows to set up the duration of the relay’s
activation from 0.0” to 15' 0 (default 1' 00). Upon
expiring timer, the relay becomes disabled.
no
the relay of the courtesy lights does not come
automatically activated.
CiCL
the relay comes activated during the barrier’s movement
phases; when the barrier is in idle mode (opened or
closed) the relay still remains active for the time set up
in the next submenu.
If option
LP.PA
is set in action the relay is also held
active during the pause.
Summary of Contents for ZENIA
