12
- Place the rear frontplate in its original position and use screws to attach it.
Block the cable
here with a cable tie
Block the UVC box
with lateral screws
Metal flaps shall
be positioned
under the cable
Plug the “tamper”
cable here.
Installation of the UVC box:
- Position UV-C box in the left part of the rear
frontplate, paying attention to the cablings.
Make sure to tie the tamper cable up and that
the UV-C box flaps are positioned under the
cable.
- Fix the box with the lateral screws and plug
the connector coming from the “tamper cable”
to the board