19
20.00%
32.61
10.00%
72.53
7. Instructions & Safety Warnings
7.1 Transportation
Transport the UPS system only in the original package to protect from damage.
7.2 Preparation
Condensation may occur if the UPS is moved directly from cold to warm environments.
The UPS system must be completely dry before being operated. Allow at least two hours
for the UPS system to acclimate to a new environment.
Do not install the UPS near water or wet, high humidity environments.
Do not install the UPS where it will be exposed to direct sunlight or near heat sources.
Avoid blocking ventilation holes in the UPS enclosure.
7.3 Installation
Do not connect appliances or devices which can overload the UPS system (e.g., laser printers).
Route cables to avoid stepping on or tripping over them.
Do not connect domestic appliances (such as hair dryers) to the UPS.
Connect the UPS system only to an earth-grounded shockproof outlet which must be
easily accessible and near the UPS system.
Use only VDE-tested, or UL-marked mains cables (e.g., the mains cable of your
computer) to connect the UPS system to the building wiring outlet (shockproof outlet).
Use only VDE-tested, UL-marked power cables to connect the loads to the UPS.
When installing the equipment, ensure that the sum of the leakage current of the UPS
and the connected devices does not exceed 3.5mA.
Temperature Rating - Units are considered acceptable for use in a maximum ambient
of 40°C (104°F).
FOR PLUGGABLE EQUIPMENT, the socket-outlet shall be installed near the equipment
and shall be easily accessible.
CAUTION: The unit is heavy. Lifting the unit requires a minimum of two people.
7.4 Operation
Do not disconnect the mains cable on the UPS system or the building wiring outlet
(shockproof socket outlet) during operations since this would cancel the protective
earthing of the UPS system and of all connected loads.
The UPS system features its own, internal current source (batteries). The UPS output
sockets, or output terminals block may be electrically live even if the UPS system is not
connected to the building wiring outlet.
To fully disconnect the UPS system, first press the OFF/Enter button to disconnect the
mains.
Prevent fluids and other foreign objects from entering the UPS.
The EPO and USB circuits are an IEC 60950-1 safety extra low voltage (SELV) circuit.
This circuit must be separated from any hazardous voltage circuits by reinforced
insulation.
7.5 Maintenance, service, and faults
The UPS system operates with hazardous voltages. Repairs may be carried out only by
