13
Trim the outside with scissors. Use a knife to score the inside opening. Break open along the score lines.
Cut around the outside along the line. Make a “tape handle” and sand the top and side opening smooth and straight.
Scuff the bottom of the gun placements and the corresponding round areas of the upper deck and glue with CA.
Choose the later version on left or the earlier version on the right and trim the rear anti-aircraft gun placement.
Attach a “tape handle” and sand the top smooth and even.
Use your hobby knife or box cutter to remove any plastic bits around the inside of the placement. After scuffing
the surfaces, glue to the top of the rear-most structure of the upper deck. Gather the bridge pieces as shown.
Mark them for trimming. This bridge piece is marked on the inside, to remove the round area. Cut away the
edges with scissors. A knife is best to score the roof of the bridge.
