Vacmaster VJF910PF 0201, Operator'S Manual

8

UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY

1. Verify that the power cord is disconnected from the outlet (Fig. 1).

2. Undo the latches (Fig. 2).

3. Lift the power head off the collection tank (Fig. 3).

4. Remove the contents from inside the collection tank; make sure you have all contents as listed 

on page 7 (Fig. 4). 

5. Turn the collection tank upside down and insert the four caster feet into the slots on the 

collection tank and tighten with supplied screws. Verify that the casters are mounted correctly. 

Do not over-tighten screws (Fig. 5).

6. Position the hose storage rack as illustrated. Squeeze the open sides of the hose storage rack 

inward. Insert the hose storage rack into the channel on the front side of the power head just 

above the top edge of the tank. Verify that the rack is secured in place as shown in Fig. 8. Then 

squeeze in the other hose storage rack and insert it into the corresponding channel making sure 

it is secured (Fig. 6 - 9).

A Philips head screwdriver is required. 

GENERAL ASSEMBLY INSTRUCTIONS

WARNING:

 DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE 

SURE THE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY 
VACUUM. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.

3

16

15

4

1

2

5

8

9

6

7

10

11

12

13

14