9
DRY VACUUMING
7. Your vacuum comes ready for dry vacuum cleaning. If the cartridge filter is not installed, refer to
page 14 for installation instructions (Fig. 10 & 11).
8. For wet vacuum cleaning, remove the cartridge filter, and install the supplied foam wet filter.
See page 15 for the foam wet filter installation instructions (Fig. 12).
9. Place the power head back on the collection tank and secure into place using the latches
(Fig. 13 & 14).
10.Insert the larger end of the hose into the vacuum port on the collection tank and lock into place
(Fig. 15).
11.Choose the desired accessory and insert onto the end of the hose. (Fig. 16).
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than the
other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do
not change the plug in any way. Double insulation eliminates the need for the three wire
grounded power cord and grounded power supply system.
DRY VACUUM OPERATION
3
4
1
2
5
8
9
6
7
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION
ENTITLED “IMPORTANT SAFETY INSTRUCTIONS”. DO NOT VACUUM IN AREAS
WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR.
FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER
FLUID, SOLVENT TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL,
OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO:
COAL, MAGNESIUM, GRAIN, OR GUN POWDER. TO REDUCE THE RISK OF HEALTH
HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
Summary of Contents for VJF910PF 0201
Page 17: ...17 EXPLODED VIEW...
