Installation
vacon • 11
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
3.3.2
Lifting enclosure sizes MM4-MM6 and MR4-MR9
Figure 1. Lifting enclosure sizes MM4-MM6 and MR4-MR9
3.3.3
Lifting VACON® 100 IP00 Drive Modules MR10/MR12 without options
1
Remove the drive from the cardboard box or the pallet where it was bolted to.
2
Use a lifting device that is sufficiently strong for the weight of the drive.
3
Put the lifting hooks symmetrically in a minimum of 2 holes.
4
The maximum lifting angle is 45°.
1
Remove the drive from the package.
2
Make sure that the support (A in Figure 2) is attached to the bottom of the drive.
It gives the terminals protection when you lift the drive or put it vertically on the floor.
3
Use a lifting device that is sufficiently strong for the weight of the drive.
4
Put the lifting hooks in the holes on the top of the cabinet. The maximum lifting angle
is 60°.
5
After the lifting, you can remove the support if necessary. You can also use it as a fix-
ing bracket.
15640_00
≤45°
≤45°
≤45°
