INSTALLATION
vacon • 11
24-hour support: +358 (0)201 212 575 • Email: vacon@vacon.com
DC switch
DC switch
DC- terminals
DC+ terminals
PE busbar
AC switch
AFE unit
Control
unit
L1, L2, L3
Opening for
cables
PE terminals
(8 pcs)
AC switch
Emergency
stop
Figure 4-2. Pricipal drawing of inverter modules NXV0040 and NXV0100 with some essential components
Due to the heavy weight of the device, it must be placed on a firm and horizontal surface.
The equipment has to be installed in a place where the room temperature is between -10ºC and
+40ºC. Lower temperatures prevent the equipment from starting up and higher temperatures limit
the output power.
The buzzing noise occurring during the operation of the equipment is normal. Do not install the
equipment in an occupied dwelling.
NOTE: It is important to prevent small particles falling onto the device. Small particles
may enter the equipment through the ventilation grids and damage the equipment.
Do not block the ventilation grids.
Unit must be installed on non-flammable ground.
The unit is not intended for wet location.
Summary of Contents for NXV0010
Page 44: ...Vacon distributor...