page 15 of 56
+
Do not use this product in an area where it can fall or
be pulled into water or other liquids.
+
Pay attention to the
permissible maximum ambient
and gas inlet temperatures
• Adopt suitable measures in case of differences from
recommended conditions, e.g., using the equipment
outdoors, installation in higher altitudes, conductive
pollution or external condensation on the pump.
• Do not operate this product near flames.
To the best of our knowledge the equipment is in com-
pliance with the requirements of the applicable EC-direc-
tives and harmonized standards (see ”Declaration of Con-
formity”) with regard to design, type and model. Directive
EN 61010-1 gives in detail the conditions under which the
equipment can be operated safely (see also IP degree of
protection, „Technical data“, pg. 23).
Operating conditions
➨
These pumps are not approved for operation in po-
tentially explosive atmospheres.
Do not operate the
pumps in potentially explosive atmospheres.
➨
Pumps
without the
”
”
mark on the rating plate
are
not approved
for the
pumping of potentially explo-
sive atmospheres
.
Do not pump potentially explo-
sive atmospheres
with those pumps.
➨
Pumps
bearing the
”
”
mark on their rating plates
are
approved for the pumping of potentially explo-
sive atmospheres
according to their ATEX classifica
-
tion imprinted on their rating plate, but they are
not
approved for operation in potentially explosive at-
mospheres
(see section „
`
Important information:
Equipment marking (ATEX)“, pg. 21)
.
NOTICE
Summary of Contents for ME 16C
Page 54: ...page 54 of 56...
Page 55: ...page 55 of 56...
