vacuubrand VACUU-BUS, Instructions For Use Manual

13

20901660_EN_VACUU·BUS-CommunicationKit_V2.0_070920

Connection

3  

3   Connection

Connection

3.1  

3.1  Cable adapters, general

Cable adapters, general

Connect cable adapters

1. 

1. Disconnect the device power plug or switch off the power 

switch.

2. 

2. Connect all required components of the Communication Kit 

as shown in the illustrations in chapter 2.2.

3. 

3. Connect the VACUU·BUS connector or socket to the 

corresponding VACUU·BUS port on the device.

4. 

4. Connect the USB adapter to a free USB port on your terminal 

device and, if required, install the driver software from the 

enclosed CD ROM.

5. 

5. Refer to the manual of the VACUU·BUS component or your 

laboratory software for how to install an update or establish 

data transfer.

3.2  

3.2  VACUU·PURE

VACUU·PURE

The cable adapter labeled 

 is intended 

solely for VACUU·PURE vacuum pumps for updates and as a 

Modbus RTU interface. Communication can only be established 

with suitable software, e.g., LabVIEW, Modbus Poll, etc.

Cable adapter with VACUU·BUS socket

2

3

1

* VACUU PURE ONLY

1

Cable adapter for VACUU·BUS socket/D-sub 

2

RS-485 / USB-A adapter

3

USB-A extension cable



 Example

View of installed 

cable adapter