background image

PREPARING FOR INSTALLATION

Inspect your pump, ensuring that it is well packaged and has not been damaged in transport. If the pump is damaged, report it to the Reece 

branch where the pump was purchased. Warranty of these pumps is void unless they are operated in accordance with these instructions.

PUMP PROTECTION

Avoid using the electrical cable to lift or transport the pump.

VADA - V75-S

The pump is designed to be used with clean water 

in a residential application. Do not use it with 

alternative fluids, specifically abrasive, corrosive 

or explosive fluids. Do not install or operate your 

pump in an explosive environment or near 

combustible matter.

Incorrectly installed or tested equipment may fail, 

causing severe injury or property damage.

Fire and burn hazard. Modern motors run at high 

temperatures. To reduce risk of fire, do not allow 

leaves, debris, or foreign matter to collect around 

the pump motor. To avoid burns when handling the 

motor, let it cool for at least 20 minutes before 

trying to work on it. A thermal overload switch 

protects the motor from heat damage during 

operation.

If the supply cord is damaged, it must be replaced 

by the manufacturer, it’s service agent or similarly 

qualified persons in order to avoid a hazard 

Children should be supervised do ensure they do 

not play with the appliance

Only qualified, licensed personnel should install 

pump. The electrical installation shall be in 

accordance with the national wiring rules (AS/NZS 

3000) for class 1, IP44 rated products.

These instructions are a guide only. Users not 

familiar with pumping equipment should seek 

advice from people experienced in pump equipment 

and installation.

Freezing conditions will damage the unit, because 

when water freezes it expands. Ensure that the 

pump is located so that it is not prone to freezing, 

or ensure that the product is disconnected and 

dried of water during cold conditions.

Pollution of the liquid could occur due to leakage of 

lubricants

The pump is electrically connected. Ensure that it 

is isolated from electrical supply during installation 

and any subsequent service work.

This appliance is not intended for use by persons 

(including children) with reduced physical, sensory 

or mental capabilities, or lack of experience and 

knowledge, unless they have been given supervi-

sion or instruction concerning use of the appliance 

by a person responsible for their safety

INSTALLATION

Please pay careful attention to the following warnings signs and indications.

Summary of Contents for V75-S









Reviews: