©2008 Vaddio - All Rights Reserved Reproduction in whole or in part without written permission is prohibited. Specifications are subject to change
without notice. Vaddio is a registered trademark of Vaddio. All other trademarks are property of their respective owners. Toll Free: 1-800-572-2011,
Main: 763-971-4400, FAX: 763-971-4464. vaddio.com Document Number 341-710 Rev. B
Installation and User Guide
Offset Drop Down Mount for
Large PTZ Cameras
Model # 535-2000-294 (for Sony Cameras)
Model # 535-2000-295 (for Panasonic Camera)
NOTE: The Offset Drop Down Mount is intended to be attached
to a third-party manufacturer’s (i.e. Peerless®, Chief®, PDR®,
etc.) pipe mounting hardware. If third party hardware includes
1.5” NPT pipe, a 1.5” to 1” reducer will be required to connect to
the Vaddio Offset Camera Mount.
Step 1:
After installing the third-party mounting hardware that the Offset Pipe Mount is to be connected
to, installation of the Vaddio Offset Drop Down mount may proceed.
Step 2:
Tighten the offset pipe onto the third-party pipe mount hardware using a strap wrench to
prevent damaging paint on the offset pipe.
Step 3:
For Vaddio WallVIEW PRO and CCU Installations: Place the EZIM box on the inside of the
back panel of the camera platform, and attach the EZIM with the supplied screws.
Step 4:
Thread the 1.25” - 12 x 7/16” hex jam nut onto the bottom threads of the offset pipe.
Mounting holes for PTZ cameras
and the WallVIEW EZIM
Camera and Electronic Products for Integrators
Heavy gauge steel with
durable black powder
coat finish (paintable to
match any décor)
Figure 1:
Offset Drop Down Mount
with features highlighted
Cable pass-thru (side of pipe) for
Quick-Connect Cat. 5 cabling
1” NPT Pipe Thread
