WEBBi - Web Controller
Vaddio WEBBi - Web Controller - Document Number 342-0445 Rev B Page 6 of 24
Equipment Descriptions and Call-outs
Diagram: WEBBi Front Panel
1) Recessed Power/Reset Button
: Resets and reboots the WEBBi device with push button activation.
2) LCD
Display:
Scrolls current IP Address across the screen when the unit is plugged in.
3) RS-232 LED Indicators:
Blue LED indicators for both the Audio & Video port connection to the EasyUSB
Tool devices. LED will flash when communication activity is detected with the device under control.
4) Network LED Indicators:
LEDs will
flash blue to indicate detection of Ethernet activity between web server
and attached browser client.
5) Power LED Indicator:
This LED will illuminate blue when power is detected.
Diagram: WEBBi Rear Panel
1) Power
Connector:
5.5mm OD x 2.5mm ID coaxial connector, positive center for supplying power to device.
Use with 12 VDC, 1.0A power supply included in package only.
2) DIP
Switches:
Used to reset device to factory defaults. Setting all dip switches to the off-position will reset
the unit to factory defaults on the next power cycle. User will lose all programmed configurations on the
factory default operation.
3) Audio
Control:
RJ-45 connector with RS-232 functionality (see appendix for pin-out). RS-232 Control port
for use with Vaddio EasyUSB Mixer/Amp. .
4) Video
Control:
RJ-45 connector with RS-232 functionality (see appendix for pin-out). RS-232 Control port
for use with Vaddio HD-USB PTZ Camera or AutoPresenter.
5) USB:
For future use.
6) Network:
10/100 Ethernet port for connection to the Local Area Network.
7) IR
Port:
For future use.
➌
➎
➍
➊
➋
➌
➎
➍
➊
➋
➏
➐
