BaseSTATION
Vaddio BaseSTATION - Document Number 342-0756 Rev A
Page 36 of 40
Appendix A: Network Information Required
The intent of this appendix is to assist both system integrators and IT managers preparing for the installation of the
BaseSTATION conferencing platform into the Enterprise IP and VoIP network.
For each BaseSTATION and room PC, three (3) total IP addresses are required. The addresses are as follows:
1) For the BaseSTATION for UC conferencing
2) For the BaseSTATION VoIP conferencing
3) For the in-room PC used with the UC conferencing application.
For the first BaseSTATION IP address (Non-VoIP):
The BaseSTATION IP address information (for non-VoIP) is entered under the
Networking Menu
tab. The
following items will need to be entered:
1)
Hostname
: ____________________________________________________. The Hostname is a label used
for identification of the BaseSTATION UC conferencing device connected to the network.
2)
Network Type:
DHCP or Static
.
If DHCP, then the address information should auto-fill
3) If
Static
, then the following information is needed (the MAC address is provided).
IP Address: _________________________________________________
Subnet Mask: _______________________________________________
Gateway: ___________________________________________________
For the 2
nd
BaseSTATION IP Address (VoIP):
The BaseSTATION IP address information for VoIP is entered under the
VoIP Menu
tab. The following items will
need to be entered:
1)
Hostname
: ____________________________________________________. The Hostname is a label used
for identification of the BaseSTATION VoIP conferencing device connected to the VoIP network.
2)
Network Type
: DHCP or Static
.
If DHCP, then the address information should auto-fill
3) If
Static
, then the following information is needed (the MAC address is provided).
IP Address: _________________________________________________
Subnet Mask: _______________________________________________
Gateway: ___________________________________________________
DNS Server: ________________________________________________
4)
VLAN:
The following Information is required if the Host site uses segmented VoIP and data to prioritize VoIP
over data traffic on the LAN/WAN (essentially the network QoS - the car pool lane for VoIP).
❒
VLAN Enabled (If enabled then ID and User Priority are required)
ID#:______________________ User Priority#:______________________
Under the
SIP Settings
Tab the following information must be entered under the headings SIP Authentication, SIP
Outbound Proxy and Session Timers:
SIP AUTHENTICATION
User Name/Extension
(User Name/Extension is used by the SIP Server to route calls):________________________________________
Password
(Password authentication to the SIP server): __________________________________________________________________
Display Name
(Acts as caller ID for the call destination): _________________________________________________________________
User Domain
(SIP IP address or Domain Name): _______________________________________________________________________
Local SIP Port
(Default Port is 5060): ________________________________________________________________________________
SIP OUTBOUND PROXY
Proxy/URL Address
(Address for SIP Outbound Proxy Server): __________________________________________________________
Proxy Port
(Default Port is 5060): ____________________________________________________________________________________
SESSION TIMERS
Registration Lifetime
(Default is 3600 sec):
___________________________________________________________
Keep Alive Timer
(Click to Enable - Enter Timer Value - Default is 30 sec): __________________________________________________
All manuals and user guides at all-guides.com
all-guides.com
