ClearVIEW HD-20
SE
QUSB
S
YSTEM
ClearVIEW HD-20
SE
QUSB
S
YSTEM
,
Document Number 342-0936 Rev C
Page 12 of 46
I
NSTALLATION
P
ROCEDURES
Before Installing the Camera:
Choose the camera mounting location while paying close attention to camera viewing
angles, lighting conditions, possible line of site obstructions, and checking for in-wall
obstructions where the camera is to be mounted. Always pick a mounting location that will
optimize the performance of the camera. Please locate the camera to enable easy
positioning of the camera body with the ability to point down and away from the ceiling and
a pile of fluorescent lighting cells.
Cameras generally don’t like to be swamped with
fluorescent light and nobody sits on the ceiling anyway
.
Installation Basics:
This camera system was specifically designed for installation on a vertical wall surface with Cat-5e
cable connectivity for Video, Power and Control signaling (two Cat-5e cables are required with the
QUSB system). This cabling ideology is especially convenient when the camera location is not
anywhere near to an AC outlet. Installation is simplified in that no custom 8-Pin mini-din cables or
expensive plenum coax cables or multi-pin cables are needed and no power outlets are required
near the camera bracket. All Cat-5e cabling is routed to the head-end using with standard straight
through RJ-45 connectors (568B termination).
“Pass-thru” type RJ-45 connectors should be
avoided, like rocking-out on top of a ladder, which should be avoided too.
General Installation Instructions for the CONCEAL Wall Mounting System:
Step 1: Determine Camera Mount Location
After determining the optimum location of the camera system, route both of the required Cat-5e cables from the
camera to the head-end. Mark the cables EZ-POWER VIDEO and RS-232 accordingly.
Both Cat-5e cables should feed-through a 1” (25.4mm) opening (circular or square shape) centered in the
rectangular slot located on the rear flange of the CONCEAL Wall Mount Bracket.
Note:
Do not cut out the entire rectangular slot opening in the wall! This will not allow the two lower wall
anchors to correctly fasten the CONCEAL bracket to the wall.
If the bracket is to be mounted on a 2-gang wall box, use the screws supplied with the wall box cover plate to attach
the CONCEAL Wall Mount Bracket. If mounting to drywall with wall anchors, use the four (4) quality wall
anchors/screws provided.
Note:
The mounting holes are slotted and are 90° opposing to provide easy leveling. Level the mount and tighten
the mounting screws. The example of the CONCEAL mount shows an HD-USB, but the steps are identical for the
HD-20
SE
.
Note:
Check all Cat-5e cables for continuity in advance of final connection. Plugging the POWER/VIDEO
Cat-5e cable into the wrong RJ-45 may cause damage to the camera system and void the warranty!
CONCEAL Wall Mount Bracket:
Cabled and Attached to Wall
Camera aligned and attached to the
CONCEAL Wall Mount Bracket (by
two-(1/4”-20) screws in the bottom of
the mount).
