ClearVIEW HD-20
SE
QUSB
S
YSTEM
ClearVIEW HD-20
SE
QUSB
S
YSTEM
,
Document Number 342-0936 Rev C
Page 17 of 46
Q
UICK
-C
ONNECT
USB
I
NTERNAL
W
EB
P
AGES AND
C
ONTROL
The internal web pages will allow control of the Quick-Connect USB and control of the attached camera via a
network connection. These web pages will allow the user or administrator to set security passwords, change the
IP address, view diagnostics, access the firmware upgrade page and more!
DHCP IP Set-up (Dynamic Host Configuration Protocol)
DHCP Set-up (skip this section if Static IP). If the LAN has a DHCP (dynamic host configuration protocol) server, then the IP address,
gateway and routing information will automatically be assigned. The QC-USB software is defaulted to DHCP and will attempt to dynamically
obtain an IP address using DHCP, but it will fall back to the default address of (169.254.1.1) if no DHCP server can be found.
Static IP Set-up:
The static IP can be assigned either through the network or directly to a computer using a cross-over cable. Depending on the age of the
computer, you may not need a cross-over cable. Either way the steps are the same for network or direct connection to a computer. The default
address of the QC-USB camera is 169.254.1.1 and the Subnet mask is 255.255.0.0. Different computer OS types all have their own way of
doing things (without question), but they are essentially doing the same stuff, changing the IP address so the web pages of the HD-USB are
accessible
.
Quick-Connect USB Web Pages Tour:
Screen Shot: Login
The webserver is intended as a user’s camera control page at one level, and an administrator’s management tool
at another level, which requires password authentication for full access.
The Login Page will appear if there is a user name assigned by the administrator. Assigning a user name can limit
access to the admin menus by a general user.
By default, the User name is:
user
, and the password for the User account is:
password
.
The Administrator can set the name and password for the User account.
By default, the Admin user name is:
admin
, and the password for the admin account is:
password
If a user or an admin logs in through this screen, then the next page shown will be the camera control page.
The user will only have access to the camera control page.
The Admin will have complete access to all web pages.
