Status Light
The light in the camera's face indicates its current state.
Note
By default, the camera's status light is active during normal operation; however, it can be configured to
remain off when the camera is powered up. The camera may be sending video even if the indicator light is
off.
n
Blue:
Normal operation (blinks off momentarily when the camera receives a command from the remote)
n
Purple:
In standby mode or booting
n
Yellow:
Firmware update in progress – overrides status light configuration
Camera assembly numbers 998-9968-001 and 998-9968-100:
Note
This product contains a Class 1, 650 nm red laser pointer.
Cet appareil contient un pointeur laser de la Classe 1, à lumière rouge de 650 nm.
Camera assembly number 998-9968-000 only:
Caution
This product contains a Class 3 (5 mw) 650 nm red laser which produces visible laser radiation. Avoid
direct eye exposure. Do not look at the laser aperture during camera operation.
All DocCAM 20 HDBT part numbers:
Caution | Avertissement
Laser light – Avoid direct eye exposure. Do not look at the laser aperture during camera operation.
Lumière de laser – Ne regardez pas directement dans le faisceau laser. Ne regardez pas directement dans
l'ouverture laser lorsque la caméra est en marche.
4
Configuration and Administration Guide for the DocCAM 20 HDBT Ceiling-Mounted Document Camera
