Restoring Default Camera Settings
This returns the camera to its original state. If you export the camera's configuration before restoring
factory defaults, you will be able to restore the room label, time zone information, and home information
by importing the configuration afterward.
Using the IP button on the connector panel:
Disconnect the network cable. Then press and hold the
IP button while reconnecting the cable. Continue to hold the button for about 10 seconds.
From the web interface:
Log on using the admin account, go to the System page's Firmware tab, and
select Restore Factory Settings.
Operation, Storage, and Care
For smears or smudges on the product, wipe with a clean, soft cloth. Use a lens cleaner on the lens. Do
not use any abrasive chemicals.
Keep this device away from food and liquids.
Do not operate or store the device under any of the following conditions:
n
Temperatures above 104° F (40° C) or below 32° F (0° C)
n
High humidity, condensing or wet environments
n
Inclement weather
n
Severe vibration
n
Dry environments with an excess of static discharge
Do not attempt to take this product apart. There are no user-serviceable components inside.
63
Complete Manual for the IntelliSHOT-M Auto-Tracking Camera
