Installing the Camera
This section covers:
n
Selecting the location for the camera
n
Installing the camera mount
n
Information on cables and RS-232 communication
n
Settings for the physical switch(es) on the camera
n
Connection diagrams
n
Mounting the camera
And a required safety note here:
Note
PoE type networks connected to this equipment are for intra-building use only and should not be connected
to lines that run outside of the building in which this product is located.
Don’t Void Your Warranty!
Caution
Always support the camera's base when picking it up. Lifting the camera by its head or mounting
arm will damage it.
Caution
This product is for indoor use. Use an appropriate protective enclosure if installing it outdoors or in a humid
environment.
Do not install or operate this product if it has been dropped, damaged, or exposed to liquids. If any of these
things happen, return it to Vaddio for safety and functional testing.
Caution
If using a DC power supply with this product, use the power supply included with it or recommended for use
with it. Always check the output voltage listed on the power supply label, as power supplies for different
products may look nearly identical. Using the wrong power supply will void the warranty, possibly causing
unsafe operating conditions and damage to the product.
Before You Start
Things to keep in mind when deciding where to install the camera:
n
Consider camera viewing angles, lighting conditions, line-of-sight obstructions, and in-wall
obstructions.
n
If the IR Remote Commander will be used, ensure that nothing blocks the IR lens in the camera's base.
n
Ensure that the camera body can move freely and point away from the ceiling and lights.
11
Complete Manual for RoboSHOT HDBT High-Performance PTZ Cameras