Installing the Camera
Do this only after verifying that the camera powers up properly. See
Pre-Installation Functional Check
for
details.
1. Place the camera assembly in the enclosure, with the face in front of the tabs. If the enclosure has a
smart glass cover, ensure that the cable for the cover panel is accessible.
2. Attach the camera to the tabs using four 1/4 in. 6-32 screws.
3. Connect the camera cable.
Installing the Interior Side Panels
The two interior side panels are not interchangeable. The right side panel has a cut-out for the smart glass
cable.
To install each interior side panel:
1. Insert the tabs into the slots in the back of the enclosure.
2. Rotate the interior side panel into place. If the enclosure has a smart glass cover, ensure that the smart
glass cable passes freely through the opening in the right side panel.
3. Secure the side panel with 1/4 in. 6-32 screws.
Installing the Cover
Do this only after verifying that the camera powers up properly. See
Pre-Installation Functional Check
for
details.
1. If the enclosure has a smart glass front frame, connect its cable.
2. Position the front frame over the front of the enclosure, being sure that the cable (if used) is not pinched.
3. Attach the cover using 3/8 in. 6-32 screws.
12
Installation Guide for the RoboSHOT IW Architectural PTZ Conferencing Camera
