IN-Ceiling Half-Recessed Enclosure for HD Series and RoboSHOT Cameras
IN-Ceiling Half-Recessed Enclosure Manual
●
Document Number 342-0177 Rev. E
Page 6 of 8
Spacer Block for HD-20 Camera:
When using the 999-2225-050 kit and the HD-20
SE
/20/22/30/USB
PTZ cameras, use the camera platform spacer to boost the height
of the camera through the enclosure collar ring as shown on right.
These cameras are approximately ¾” shorter than the HD-18 and
HD-19 and the spacer puts the camera head and lens in the
correct position. Use the two (2) ¼”-20 x 1.125” screws to fasten
the camera to the enclosure through the spacer block.
RoboSHOT Camera:
The 999-2225-150 kit is designed for use only with the RoboSHOT
Series of cameras. No spacers are required as the rear box is
reduced in depth to allow for correct positioning of the shorter
camera.
Use the ¼”-20 x .375” machine screw to fasten the camera to the
enclosure back.
Step 7:
Add Black felt IR shield ring over the top of the camera, route the 18” IR Receiver cable through the small
hole and set the ring down over the PTZ camera with the camera protruding though the large hole in the felt shield.
When inverted, the lid and camera will keep the felt correctly oriented and centered.
Step 8:
Attach the lid with the bezel color ring with the four (4) 6-32 x .25” black flat head screws. Pull the 18” IR
cable through the lid first. This will be attached to the trim ring IR receiver board, but after it is placed in the ceiling.
Step 9:
Carefully put the camera assembly on top of the ceiling tile support brace, and slip the camera head through
the opening in the installed tile support brace and the ceiling tile (see Step 3).
Step 10:
Attach the IR receiver cable to the trim ring and work the cable back into the enclosure through the slot
in the bezel collar ring opening. Take care to avoid restriction of the camera movement with all cables. Attach the
trim ring with the provided white
6-32 x .5 flat head screws
.
Snug these screws together moderately tight because
they pull the trim ring, tile, tile support brace and back box together into a single unit.
Step 11:
Connect the other side of the Cat-5e cables (Power/Video and RS-232) to the Quick-Connect as described
by the manual included with the camera package.
IR Receiver
Board on
Trim Ring
(Step 10)
HD-20
SE
/20/22/30/USB
Spacer Block
6-32 x .25” Screws
attach the lid at the
corners
Black Felt
IR Blocker
Pull IR Receiver
Board & Cable
trough Felt Shield
