TrackVIEW Install Guide 341-337 Rev. E
Page 2 of 32
TrackVIEW and Peripherals Install Guide
•
IR Remote Controller
The system employs a multi-function IR remote controller for preset programming and camera control.
•
Built-in EZCamera Cabling System Quick-Connect™ Box
When using the TrackVIEW 100 and 70 the reference and tracking camera inputs have built-in Quick-
Connect boxes for running power and video over a single Cat. 5 cable. When using the EVI-HD1 as the
Tracking camera, the external Quick-Connect PRO and EZIM are required.
•
PowerRite™ Power Supply
The TrackVIEW internal PowerRite power supply is sized to power the five triggers (AutoVIEW IR and
StepVIEW triggers) and two PTZ cameras in the TrackVIEW 100 and 70 systems. The inputs also have a
15V/18V power selection switch for Cat. 5 power/video cables to match the cameras power requirements as
the cable distance to the camera increases (see Table 1 on pg. 9). If the EVI-HD1 is used as the tracking
camera, the Quick-Connect PRO and EZIM are powered by an external PowerRite 36VDC power supply.
•
USB and DB-9 Connection for System Set-up and Software
The system set-up port is on a USB connection to eliminate the need for the installer to find a laptop with a
DB-9 RS-232 port. The system software is intuitive and easy to use to maximize system performance and
provide for quick set-ups.
(Note: USB overrides serial port. The serial port is disabled when using USB)
INTENDED USE:
Before operating the TrackVIEW system, please read the entire manual thoroughly. The system was designed,
built and tested for use indoors with the provided power supply. The use of a power supply other than the one
provided or outdoor operation has not been tested and could damage the electronics and/or create a potentially
unsafe operating condition.
SAVE THESE INSTRUCTIONS:
The information contained in this manual will help you install and operate your Vaddio TrackVIEW. If these
instructions are misplaced, Vaddio keeps copies of Specifications, Installation and User Guides and most
pertinent product drawings for the Vaddio product line on the website. These documents can be downloaded
from
www.vaddio.com
free of charge.
IMPORTANT SAFEGUARDS:
Read and understand all instructions before using. Do not operate the system if it has been dropped or
damaged. In this case, a Vaddio technician must examine the product before operating. To reduce the risk of
electric shock, do not immerse in water or other liquids and avoid extremely humid conditions.
Use only the power supply provided with the TrackVIEW system. Use of any
unauthorized power supply will void any and all warranties.
