ProductionVIEW FX - Firmware Version V02.01.07
ProductionVIEW FX Manual 341-451 Rev. B
Page 10 of 18
Pan Speed
>Select
>01
–
24
Sets the Pan Speed on all cameras between camera presets (24 is fastest) (default is 18)
(This parameter does not affect the Pan Speed or sensitivity of the Joystick)
Pan Dir Menu
(Pan Direction Menu)
>Select
>All Ports: Normal or Invert (default is Normal) Inverts the Joystick Pan Direction (Inverted - left = right)
>Port 01: Normal or Invert
>Port 02: Normal or Invert
>Port 03: Normal or Invert
>Port 04: Normal or Invert
>Port 05: Normal or Invert
>Port 06: Normal or Invert
>Return to Main
>Select
Returns
to
Main
Menu
Tilt Speed
>Select
>01 – 20 (default is 15)
Sets Tilt Speed on all cameras between camera presets (20 is fastest)
(This parameter does not affect the Tilt Speed on the Joystick)
Tilt Dir Menu
(Tilt Direction Menu)
>Select
>All Ports: Normal or Invert (default is Normal) Inverts the Joystick Tilt Direction (Inverted - up = down)
>Port 01: Normal or Invert
>Port 02: Normal or Invert
>Port 03: Normal or Invert
>Port 04: Normal or Invert
>Port 05: Normal or Invert
>Port 06: Normal or Invert
>Return to Main
>Select
Returns
to
Main
Menu
Zoom Direction
>Select
>Normal or Invert (default is Normal)
Inverts the Joystick Zoom Direction (Inverted - Clockwise twist = zoom out)
Ext Triggers
(Automatic Mode)
>Select
>6 Cam 1, 6 Cam 2
>All 12 Cam 1
External Trigger Assignment - 6 triggers each for cameras 1 and 2, or all 12 triggers for camera 1 presets (6 & 6
is default)
Ext Preset Dir
>Select
>Input or Output
For Multi-function Triggers
Input = Triggers for channels 3 through 6, triggering Preset 1 for each camera only
Output = Logic outputs for channels 3 through 6 on the main bus (default is Input Triggers)
Sel Follow Prv
(Select Follows Preview)
>Select
>Yes
or
No
Camera Selection follows Preview Input Selection – Recommended “Yes” selection
When activated, camera selection switching follows the Preview bus selection, immediately transferring joystick
and camera control directly to the camera selected on the Preview bus (default is No or off)
Panel Lights
>Select or Cancel
>00
through
50
Panel Light Brightness (all lights - 50 is the brightest) (default is 25, off is 00)
System Menu
>Select
>Serial Input
>Select
>Yes
or
No
Turns on or off serial input (default is Yes or On)
