WallVIEW 50i HideAway – Document 341-141 Rev. C
Page 2 of 14
Read and understand all instructions before using. Do not operate
the camera if the camera has been dropped or damaged. In this
case, a Vaddio technician must examine the appliance before
operating. To reduce the risk of electric shock, do not immerse in
water or other liquids and avoid extremely humid conditions.
Carefully remove the device and all of the parts from the packaging.
Unpack and identify the following parts:
•
One (1) WallVIEW 50i PTZ HideAway camera enclosure
module
o
Contains Canon VC-C50i Camera inside
•
White surrounding trim plate with door cut out
•
White door cover plate
•
Canon WL-V5 Multifunction IR Remote
•
EZCamera Control Adapter
•
EZCamera Quick-Connect Box
•
Vaddio PowerRite 15 VDC Power Supply and Power Cable
•
One (1) 12’/(
3.6
6m) S-Video Cable
•
One (1) 12’/(
3.6
6m) Composite Video Cable
•
Installation and Users Guide (document 341-141)
•
Mounting Template (document 341-156)
•
Mounting
hardware
The WallVIEW 50i PTZ HideAway is an unique recessed approach
to camera system installation. While the camera is easy to install,
understanding of the key system components is essential.
The WallVIEW 50i PTZ HideAway is shipped closed and packed
securely for transit. Before powering up the camera for the first
time, make sure that any tape is removed and the door is not
blocked (see Figure 1).
UNPACKING
Use only the power supply provided with the WallVIEW 50i HideAway camera
system. Use of any unauthorized power supply will void any and all warranties.
IMPORTANT
SAFEGAURDS
Figure 1:
Vaddio WallVIEW 50i
HideAway enclosure shown with
camera lift system (door) closed.
RJ-45 connections (for video, power
& control) and a closure pair are
shown under the lift mechanism.
Note conduit knockout on lower right
side of camera module backbox
(knockout on bottom not shown).
INSTALLATION