WallVIEW CCU HD-20 HD-SDI
WallVIEW CCU HD-20 HD-SDI Manual 342-0182 Rev. A
Page 5 of 24
ClearVIEW HD-20 PTZ Camera, Rear View with Feature Call-outs:
5) RS-232 IN & IR Out:
The RS-232 accepts modified VISCA protocol for camera control, as well as transmits
IR signaling received by the IR receivers, which can be transmitted to third party devices.
6) Dip Switch Settings:
Settings for IR remote, baud rate, SD output format, and image flip can be configured
on these switches. See page 5 for additional information on switch settings.
7) HD Video Select:
A rotary switch allows the user to choose the component HD output video resolution and
format. See page 5 for additional information on switch settings.
8) 12 VDC Input:
Power input for the standard, ClearVIEW HD-20 12 VDC, 3.0 Amp camera power supply.
9) HDMI Output:
The HDMI output feeds out HD digital video only (no copy-protect or device communication is
included). SD or SDI on the HD-SDI Slot Card are not supported.
10) YPbPr Output:
Component HD video is fed through the DB-15 connector. YPbPr and HDMI signals are
simultaneous. SD is not supported.
11) EZ Power/Video Port:
This RJ-45 connector is only used with the Quick-Connect SR Interface and the
Quick- Connect DVI-D/HDMI SR Interface to supply power and return HSDS video from the camera.
12) Slot for Optional Cards:
Optional slot cards can be plugged into the ClearVIEW HD-20 camera. For this
package, the HD-SDI Slot Card is included and shown installed above. The HD-SDI Slot Card uses a RJ-45 for a
36V power jack and two (2) HD-SDI outputs.
See Important Safeguard below.
IMPORTANT SAFEGUARD
⑥
⑤
⑧
⑦
⑩
⑨
⑫
⑪
Do not insert or remove the EZIM HD-SDI Slot Card into an HD-20 Camera when
the camera is powered ON. Detach all power connectors before installing or
removing the EZIM HD-SDI Slot Card.
