ZoomSHOT 20 QSR Camera System
ZoomSHOT 20 QSR System Document Number 342-0968 Rev A
Page 8 of 20
Image: Basic Wiring Configuration
ZoomSHOT 20 HD POV Camera with Quick-Connect SR Interface (color coded connectors) and ProductionVIEW
Precision Camera Controller.
F
IRST
T
IME
S
ET
-
UP
:
The ZoomSHOT 20 was designed to be very easy to use and operate. There is documentation at the back of this
manual for pin-outs of the connectors on the Quick-Connect and camera.
Before Installing:
Choose camera mounting location, paying close attention to camera viewing angles, lighting conditions,
possible line of site obstructions, and checking for in-wall obstructions where the camera is to be mounted.
Always pick a mounting location that will optimize the performance of the camera. Please locate the camera to
enable easy positioning of the camera body with the ability to point down and away from the ceiling and a pile
of fluorescent lighting cells.
Cameras generally don’t like to be swamped with fluorescent light and nobody sits
on the ceiling anyway
.
The Thin Profile Wall Mount for the ZoomSHOT 20 can be mounted directly to a 1-gang wall box or can be
mounted using only dry wall anchors.
For Power/Video and RS-232 signals, use standard Cat-5 cable (568B termination and real RJ-45 connectors)
from the EZ-POWER VIDEO and RS-232 ports on the back of the ZoomSHOT to the Quick-Connect SR
Interface. These jacks are
color coded
for ease of connection.
Analog Component YPbPr
24VDC, 2.08 Amp
Power Supply
HD Monitor
(Simulated HD Video Feed)
ProductionVIEW Precision Camera Controller
EZ-POWER VIDEO
Cat-5 (orange to orange)
ZoomSHOT 20
Rear View
RS-232
Cat-5 (blue to blue)
< Power to Camera - HD Video to QC SR >
Two Cat-5/5e/6 Cables
Up to 150’ (45.72m)
Quick-Connect SR Interface
(Rear Panel View)
RS-232
Cat-5
