11
10
Installation - shower
Handset
Place one of the rubber
washer into the cone end of
the hose and screw to the
handset.
Place the cone into the
bracket
Outlet
Place the second rubber
washer into the nut end of
the hose and attach it to the
mixer outlet.
Cone end
of hose
Washer
Handset
Rubber
washer
Nut end
of hose
Installation
Slide the shroud down until it makes
connect with the floor.
Be sure to keep the shroud level, and
lower both sides equally.
Finish the floor covering down to a
dimension of 90mm x 90mm.
Keep the tap/upstand protected while the
floor is being completed.
Place the base connection onto the base.
Rotate the tap/upstand until the outlet is in
the desired position.
When satisfied, secure using the x 4
supplied cap screws and washers.
90mm
90mm
