2.5. Aftermarket rear view camera connection:
- Rear gear bulb signal -> Input no “85” Relay
- 12+ ignition -> Input “30” Relay
- Ground -> Input “86” Relay
- Relay’s output (To the Multimedia interface grey cable) -> Input “87” Relay
ATTENTION; NEW AUDI CARS MODEL YEAR FROM 2011 TO NOWADAYS,
REAR LIGHT SIGNAL NEEDS TO INSTALL A RELAY TO FILTER SIGNAL PULSES.
PLEASE PAY ATTENTION TO THE INFORMATION BELOW.
Follow the instructions below:
The rear gear signal mustn’t pass through any box (Filter FUSE BOX) so, you must cut the cables
connected to the filter fuse box incoming from the rear gear signal and the output from this.
Don’t forget to adjust the DIP switch #7 of the multi-
media interface once all camera connections has been
performed:
DIP Switch 7 - Enable/Disable Rear View Camera (RVC)
• DIP switch 7 UP: OEM camera enabled
(without aftermarket RVC)
• DIP switch 7 DOWN: Enable aftermarket RVC
14
You will have to connect the yellow video RCA of the camera to the “REAR C” RCA connector of the “AV
IN/OUT” interface’s wiring harness, and also will have to connect the power supply grey “REAR-C” cable
to the rear gear’s light bulb.
VERY IMPORTANT: If you don’t connect the ”REAR-C” cable to the signal from the rear light, the “CAM”
connector won’t supply power to the camera, so the camera won’t work.