2.7. Voice module installation and connections:
➢
Voice module:
➢
Audio connection cable from the voice module:
➢
Audio connection cable of the Audi Sound System voice module (9VD-9VE):
Insert to the voice module the black jack 3.5 type connector, connect the white
and the red RCA connectors to the RCA AUDIO L OUT and AUDIO R OUT connec-
tors from the “GPS Box POWER wiring harness” (red to red, white to white).
fig. 1
fig. 2
fig. 3
Specific cable to install the voice module in vehicles which have equiped the Audi
Sound System (9VD-9VE). You will have to bypass it through the vehicle’s wiring
harness and the amplifier (like image below shows).
Connect the 12 pin White connector to the Voice module Quadlock cable con-
nection port and connect the yellow loose cable to a +12V ACC ignition source.
IF VEHICLE DOESN’T HAVE ANY POWER SUPPLY NEAR THE TRUNK’S ZONE,
THEN YOU’LL HAVE TO PASS A POWER SUPPLY CABLE FROM THE VEHICLE’S
FRONT ZONE TO THE TRUNK’S ZONE.
ATTENTION; You may note that you will have to disconnect the battery before
proceed with the following steps. If you don’t disconnect it, vehicle’s amplifier
could turn on “antitheft protection mode”.
17
Voice Module with a LED Light that indicates that is working (fig. 1), Quadlock cable connection
port (fig.2), Jack connection port for the Audio cable connection and volume regulator (fig.3).
NOTE: Voice module for the audio signal to the vehicle’s front speakers.
