11
Safety
EQUIPMENT SAFETY PRECAUTIONS
OPERATING THE ATTACHMENT
•
When operating on slopes, drive up and down, not across. Avoid steep hillside
operation, which could cause the prime mover to overturn.
•
Reduce speed when driving over rough terrain, on a slope, or turning to avoid
overturning the vehicle.
•
An operator must not use drugs or alcohol, which can change his or her
alertness or coordination. An operator taking prescription or over-the-counter drugs
should seek medical advice on whether or not he or she can safely operate
equipment.
•
Never leave the attachment unattended when in the raised position. Always
make sure the attachment is on the ground, parking brake is engaged, engine is
turned off and the keys are removed before exiting the prime mover.
TRANSPORTING THE ATTACHMENT
•
Travel only with the attachment in a safe transport position to prevent
uncontrolled movement. Drive slowly over rough ground and on slopes.
•
When transporting on a trailer: Secure attachment using tie down accessories
that are capable of maintaining attachment stability.
•
Use extra care when loading or unloading the attachment onto a truck or trailer.
Disconnect hydraulic couplers during transporting when installed on prime mover.
•
When driving on public roads use safety lights, reflectors, Slow Moving Vehicle
signs etc., to prevent accidents. Check local government regulations that
may affect you.
•
Do not drive close to ditches, excavations, etc., a cave-in could result.
•
Do not smoke when refueling the prime mover. Allow room in the fuel tank for
expansion. Wipe up any spilled fuel. Secure cap tightly when done.
MAINTAINING THE ATTACHMENT
•
Before performing maintenance, disengage auxiliary hydraulics, lower the
attachment to the ground, turn off the engine, remove the key and apply the brakes.
Be sure all rotation has stopped before making any adjustments or repairs.
•
Never perform any work on the attachment unless you are authorized and qualified
to do so. Always read the operator manual’s before any repair is made. After
completing maintenance or repair, check for correct functioning of the attachment.
If not functioning properly, always tag
“DO NOT OPERATE”
until all problems
are corrected.
•
If attachment must be left raised for maintenance or any other reason, block the
unit securely to prevent accidental release of the lifting mechanism. Serious
damage or personal injury could result.
•
Worn, damaged, or illegible safety decals must be replaced. New safety decals can
be ordered from Vail Products
®
.
•
Never make hydraulic repairs while the system is under pressure. Serious personal
injury or death could result.
•
Never work under raised attachment.
Summary of Contents for PXBC2-8515/20
