Safety 1
0020237954_01 Installation instructions
25
1.3 General safety
information
1.3.1 Risk caused
by inadequate
qualifications
The following work must only
be carried out by competent
persons who are sufficiently
qualified to do so:
–
Assembly
–
Disassembly
–
Installation
–
Start-up
–
Repair
–
Decommissioning
▶
Observe all instructions that
are included with the product.
▶
Proceed in accordance with
the current state of techno-
logy.
▶
Observe all applicable dir-
ectives, standards, laws and
other regulations.
1.3.2 Risk of death from
electric shock
There is a risk of death from
electric shock if you touch live
components.
Before commencing work on
the product:
▶
Disconnect the product from
the power supply by switch-
ing off all power supplies at all
poles (electrical partition with
a contact opening of at least
3 mm, e.g. fuse or line protec-
tion switch).
▶
Secure against being
switched back on again.
▶
Check that there is no
voltage.
1.3.3 Risk of poisoning
caused by simultaneous
operation with an open-
flued combustion
location
If the product is operated at the
same time as an open-flued
combustion location, life-threat-
ening flue gas may escape into
the rooms from the combustion
location. Correct operation of
the product requires that exist-
ing combustion air pipes and
flue gas installations can be
shut off from open-flued com-
bustion locations.
▶
Install a suitable protection
device on-site, which monit-
ors the pressure difference
between the living room and
the flue gas guiding and
switches the product off if the
pressure difference is too
large.
▶
Have the installed safety
device approved by a chim-
ney sweep.
