36
Instructions on commissioning, maintenance, and troubleshooting for auroSTOR 0020111119_02
6.8.2 Electrical connection of control components
1
2
3
4
5
1
10
9
6
8
13
12
11
3
2
3
4
6
5
7
Fig. 6.11 Cylinder temperature control
Key
1 Cover cap for reset button for primary heating circuit TCO
2 Primary heating circuit temperature controller
3 Primary heating circuit cylinder dry pocket (SP 1)
4 Electric immersion heater cover
5 Casing
6 Solar circuit cylinder dry pocket (SP 2)
7 Cover cap for reset button for solar circuit TCO
8 Upper cylinder dry pocket
9 Solar circuit thermal cut-out (TCO)
10 Electric immersion heater
11 Lower cylinder dry pocket
12 Primary heating circuit thermal cut-out
13 Cylinder thermostat
The cylinder has a suitable thermal cut-out for the pri-
mary heating circuit (
12
) and solar circuit (
9
) and a cyl-
inder thermostat (
13
).
i
Before wiring the control components, dismantle
the casing (
5
) to facilitate work on
the components. When reinstalling the casing,
use the cutouts in the casings for routing the
cables.
1
2
3
7
6
5
4
Fig. 6.12 Cylinder thermostat and thermal cut-out (TCO)
for primary heating circuit
Key
1 Cylinder
thermostat
2 Cylinder thermostat protective earth terminal
3 Cylinder thermostat terminal 1
4 Primary heating circuit TCO protective earth terminal
5 Primary heating circuit TCO C terminal
6 Primary heating circuit TCO reset button
7 Primary heating circuit thermal cut-out (TCO)
1
2
3
4
5
Fig. 6.13 Solar circuit thermal cut-out (TCO)
Key
1 Solar circuit thermal cut-out (TCO)
2 Solar circuit TCO reset button
3 Solar circuit TCO terminal C
4 Solar circuit TCO protective earth terminal
5 Solar circuit TCO terminal 2
i
You must connect the solar pump’s outer con-
ductor from the solar control via terminals "3"
and "5" of the TCO solar circuit in series circuit
to the solar pump.
6 Installation
