Installation 4
0020131978_00 VRT 350f Installation instructions
13
–
Height:
≈
1.5 m
1
2
3
1
Wall-mounting base
2 Mounting holes
3 Wall-mounting base finish-
ing panel
2. Remove the wall-mounting base from the rear of the
controller by pulling the base downwards.
3. Remove the finishing panel from the wall-mounting base
by pulling the top edge of the panel away from the wall-
mounting base with your fingers.
4. Mark the position on the wall.
5. Drill two holes in line with the mounting holes
(2)
.
–
Diameter of mounting hole: 6 mm
6. Insert the rawl plugs supplied.
7. Fix the wall-mounting base
(1)
to the wall using the
screws supplied.
8. Locate the two bottom lugs of the finishing panel
(3)
in
the holes in the wall-mounting base.
9. Press the top edge of the finishing panel into the wall-
mounting base until it clicks into position.
10. Open the battery compartment on the underside of the
controller.
11. Remove the two plastic strips between the batteries and
the contacts.
12. Check that the battery poles are the right way round.
13. Close the battery compartment.
14. Hook the controller onto the wall-mounting base.
15. Press the controller down onto the wall-mounting base
until it audibly clicks into position.
16. Check the quality of the RF connection.
Summary of Contents for VRT 350f
Page 4: ...Contents 4 Installation instructions VRT 350f 0020131978_00 12 Customer service 32...
Page 33: ......
Page 34: ......
Page 35: ......