32
Installation instructions
VRT 360f
Fig. 9.1 Connection to one boiler
Install the receiver outside the heating
unit using the plinth supplied (Fig. 9.1)
• Pull the receiver (
1
) off the wall plinth
(
2
).
• Drill two holes (
3
) of 6 mm diameter
(as shown in fig. 9.2) and put in the
supplied wall plugs.
• Push the connection cable (
4
) through
the cable ducting (
5
).
• Attach the wall plinth to the wall with
the two screws provided.
• Connect the cable as described in
Chapter 10.
• Place the receiver (
1
) on the wall plinth
so that the pins on the back of the
upper section fit into the receptacles.
• Push the receiver onto the wall plinth
until it clicks.
9 Installation
Summary of Contents for VRT 360f Operating and
Page 47: ......
