User's Guide ______________________________________________________________________
64 __________________________________________________________________ M210855EN-C
Relay Settings
Relay Outputs
0705-185
Figure 35
Relay Indicators on Display
Use the display/keypad to set the relay outputs.
1.
Press any of the arrow buttons to open the
MAIN MENU
.
2.
Select
Interfaces
and press the right arrow button to confirm your
selection.
3.
Select
Relay Outputs
and press the right arrow button to confirm
your selection.
4.
Select
Relay 1/Relay 2
by pressing the right arrow button. Use the
up/down arrow buttons to select the quantity and press
SELECT
to confirm your selection.
5.
Select
Quantity
, press the
CHANGE
button. Select quantity by
using the up/down arrow buttons. Confirm your selection by
pressing the
SELECT
button.
6.
Select
Act. above/Act. below
. Press the
SET
button. You may be
asked, whether you want to modify the value or remove the
setpoint. In this case, select
MODIFY
to adjust the value or
REMOVE
to clear the setpoint. Adjust numeric values by pressing
the up/down/left/right arrow buttons. Confirm your selection by
pressing the
OK
key.
The number refers to
1
=
List enabled relays. Activation state is shown in black.
Disabled relays are not shown.
