8. Connect the logger data cable to a free port in the serial port server.
9. Mount the new PDT101 transmitter(s) on the DIN rail.
Rest the upper part of the locking mechanism on the DIN rail and push down firmly.
This will click the device into place.
10. Connect the PDT101 transmitters to the data logger and the power block, as shown in
to
.
Use the cable set for PDT, which is included in PDT Wiring Set (Vaisala item code:
ASM213079SP).
When mounting the second, third, or fourth PDT101 transmitter on the DIN rail, use the
existing wires in the cable duct below the PDT101 mounting location.
1
24 VDC power wires and connector
2
PDT101 wires
3
Data logger connector
The cable set for PDT contains wiring for 4 PDT101 transmitters. If you install only
1 to 3 PDT transmitters, leave the extra wires unconnected and the wire end caps in
place.
Chapter 6 – Adding devices to CAB100B
51
Summary of Contents for CAB100
Page 1: ...M212242EN B Installation Guide CMS Industrial Cabinet CAB100...
Page 144: ......
Page 146: ...www vaisala com...
