User's Guide _______________________________________________________________________
58 ___________________________________________________________________ M210243en-A
Protect the tops of the bolts with two nuts tightened together. Place the
combinations into the holes, anchors down, and hammer them down.
Tighten the bolts a few times to ensure that the anchors attach to the
walls of the holes. Fix the pedestals with the washers and nuts.
Alternatively, the stud bolts can be encased in concrete. In this case,
the bolts should be kept safely at the correct position during pouring
the concrete in. You should also protect the stud bolts from the
concrete during casting to avoid problems in installing the pedestals.
0201-026
Figure 44
DKP12 Attachment to a Foundation
The following numbers refer to Figure 44 above.
1
=
Mast
2
=
Pedestals 2 pcs
3
=
Nuts M10 DIN934 8 pcs
Washers A10.5 DIN125 8 pcs
4
=
Stud bolts M10x200 4 pcs
5
=
Anchor M10 L=40 4 pcs
6
=
Bolts M10x90 DIN933 2 pcs
Washers A10.5 DIN125 4 pcs
Nuts M10 DIN934 2 pcs
