12
13
EN
EN
Using the appliance
Using the appliance
C
C
Cheminée décorative supérieure
(intérieure)
Support de cheminée inférieure
Cheminée décorative inférieure
(extérieure)
Decorative upper chimney (inside)
Lower chimney bracket
Decorative lower chimney (outside)
Make two 8 mm holes in which to house plate II. Screw in and tighten plate II to the wall using
two of the screws and dowels provided. Slide the upper chimney upwards and attach it to
plate II using two 8 mm ST4 screws.
Attach the lower chimney to the hood using two 8 mm ST4 screws.
Vis
Plaque II
4x8mm
4x30mm
Plate II
4x8mm
4x30mm
Screws
Recycling version
Ask your salesperson to provide you with some active charcoal
filters to transform the hood from the evacuation version to the
recycling version.
Install the active charcoal filter (cassette)
• The aluminium filter must be removed to install the active
charcoal filter.
• Open the grating, press the locking device and pull the filter
downwards.
• Place the active charcoal filter inside the appliance and attach
it by turning anticlockwise.
• Replace the grating in its original position.
Install the active carbon filter (cut out)
• The aluminium filter must be removed to install the active
charcoal filter.
• Place the precut filter on top of the aluminium filter.
• Replace the aluminium filter.
• We recommend running the hood for a few minutes before starting to cook. We also
recommend switching it off 15 minutes after cooking has finished to eliminate odours as
much as possible and remove bad air.
NB
Make sure that the filter is properly fixed in place
Otherwise it could work loose
and present a hazard .
The installation of a carbon filter reduces the extraction power of the hood.
Installation (recycling mode)
Summary of Contents for 970142
Page 2: ...1 2 3 4 5 ...
