24
25
EN
EN
Useful information
Useful information
C
C
IMPORTANT:
• The bulb must be replaced by the manufacturer, one of
its technicians or a qualified person.
• Always switch off the power before performing any
operation on it. Before handling the bulb, make sure it
has completely cooled.
• When handling bulbs, hold them with a cloth or gloves
to ensure that sweat does not come into contact with
them, as this may reduce their life
Troubleshooting
Problem
Potential causes
Solution
The light comes on but the
motor is not working.
The fan switch is disabled.
Select a position for the fan switch.
The fan is out of order
Contact the service centre.
The motor is out of order.
Contact the service centre.
The light comes on but the
motor is not working.
The home’s fuses are
defective.
Reset / Replace fuses.
The power cord is detached
or disconnected.
Re-plug the cord into the power socket.
Switch on the power socket.
Oil leak
The check valve and the
output device have a sealing
defect.
Dismantle the check valve and seal it
using a sealant.
There is a leak on the
connection between the duct
and its cover.
Remove the duct and seal the leak.
The light is not working.
The bulbs are defective/
broken.
Replace the bulbs in accordance with
this manual.
Insufficient suction
The distance between the
hood and the stove is too
large.
Reposition the hood at the right
distance.
The extractor hood is tilted.
The mounting screws are not
tight enough.
Tighten the suspension screw by
aligning the hood horizontally.
COMMENT
:
All electrical repairs to this appliance must comply
with your local, state and federal legislation. If in doubt, contact
the service centre before undertaking anything. Always unplug
the appliance from the power source if you need to open it.
Replacement the lamp
Light source in this product can only be replaced by qualified professionals.
Please contact after-sales service if the light source fails. The light source shall be removed
at the end of the product's useful life, with sorting and recycling done separately.
• The ILCOS D code for this lamp is: DSR-1.5/65-S-64
- LED modules - round bulb
- Max power : 2 x 1.5 W
- Voltage range: 12V DC
- Dimensions: Φ64mm
