12
13
EN
EN
Using the appliance
Using the appliance
B
B
adapter with the hose. Such adapters can normally be purchased easily in appropriate outlets.
The adapter is intended to facilitate the connection to the pressure regulator hose mounted on
the cylinder.
• using a flexible rubber hose that complies with current standards. The hose should be of a
diameter of 8 mm and its length should be between 400 mm minimum and 1.5 m maximum.
This flexible rubber hose must be firmly attached to the hose connection with a safety clamp in
accordance with the applicable standards.
Check for gas tightness with a soap solution, not with gas.
CAUTION:
The gas inlet connection to the appliance is a 1/2" male
gas fitting with a cylindrical thread, in accordance with
ISO 228-1 and ISO 7-1:1994.
Make sure that the stainless steel hose and the flexible
rubber hose do not come into contact with moving parts of
the work surface (e.g. drawers), when installed.
In addition, gas pipes must not pass through compartments
used for storage purposes.
When using a rubber hose, observe the following recommendations:
• No part of the hose should come into contact with objects whose temperature might exceed 65°C.
• The hose must not be stretched, twisted, crushed or bent.
• It must not come into contact with sharp corners or edges.
• It must be possible to inspect the hose easily along its entire length to check for wear.
• The hose must be replaced before the expiry date stamped on it.
Power supply connection
The electrical connection must be made in accordance with current specifications and regulations.
Before connecting the unit, check that:
• The appliance’s operating voltage and the electrical socket is suitable for the maximum power
of the appliance (see the type plate on the bottom of the appliance).
• The socket and electrical system are correctly earthed in accordance with the relevant standards.
The manufacturer declines all responsibility in the event of non-compliance with these provisions.
When the appliance is connected to the mains supply via a plug:
• Install a standard plug on the power cable
C
(if it is not supplied with one)
(see fig.
11
). This socket must be capable of carrying the electrical load indicated on the rating
plate. Connect the wiring according to the diagram in fig.
11
, ensuring that the following
instructions are observed:
- Letter
L
(live) = brown wire;
- Letter
N
(neutral) = blue wire;
- Earth symbol = green-yellow wire.
• The electrical cable must be positioned so that no section will reach a temperature of 75°C.
• Never use reducers, adapters or shunts for this connection; These can cause a faulty contact,
may result in overheating and thus pose a significant danger.
• The power socket must be accessible after the appliance has been installed.
When the appliance is connected directly to the mains electricity supply:
• Install a double pole circuit breaker between the appliance and the mains. The size of the
circuit breaker depends on the power rating of the appliance. The opening between the power
breaker contacts must be at least 3 mm.
• The earth wire must not be connected through the circuit breaker.
• Alternatively, the electrical connection can also be protected by a high-sensitivity earth leakage
circuit breaker.
