12
EN
Using the appliance
B
Installing the active carbon filter (cut-out)
• The metal filter has to be removed before the active carbon filter is installed.
• To open the metal filter, press on the locking device and pull the filter downwards.
• Place the precut filter on top of the metal filter. Hold in position using the metal rods
(supplied according to the model).
• Replace the metal filter in its original position.
3
Make three 8 mm holes in the wall in the required position and assemble the wall
bracket. Attach using the screws and dowels provided.
4
Lift the hood and attach it to the wall bracket.
5
Connect the discharge duct
6
Slide the upper part of the chimney inside the lower part and then pull the upper part
upwards to the required height.
7
Connect the two parts together once the chimney has been positioned at the correct
height.
8
Make three 8 mm holes for the wall bracket. Attach it to the wall using the 2 screws
provided. Assemble the chimney onto the hood and attach them together with 2 screws.
Summary of Contents for TSH 90 T BG 962C(V2)
