Section 2
—
Safety Information
MCP-25/MS
Valco Cincinnati
2-2
WARNING! When making adjustments or performing checkout procedures,
stay clear of any moving mechanical parts and do not touch exposed electri-
cal equipment or electrical connectors. OTHERWISE, DEATH OR PERSONAL
INJURY COULD OCCUR.
WARNING! Keep pump cover and electrical enclosures closed except during
setup, service, and checkout procedures. OTHERWISE, DEATH OR PER-
SONAL INJURY COULD OCCUR.
WARNING! Promptly repair or replace all worn or damaged parts. OTHER-
WISE, PERSONAL INJURY OR EQUIPMENT DAMAGE COULD OCCUR.
WARNING! Always wear insulated gloves and proper eye protection when
working aound hot-melt equipment. A protective screen around the face is
also recommended. OTHERWISE, DEATH OR PERSONAL INJURY COULD
OCCUR.
WARNING! People with respiratory problems (e.g., asthma, bronchitis, etc.)
should not work in the vicinity of the molten adhesive. RESPIRATORY PROB-
LEMS MAY BE AGGRAVATED BY THE FUMES. Do not wear a face mask
when working around the molten adhesive. THE MASK MAY TRAP THE
FUMES AND DEATH OR PERSONAL INJURY COULD OCCUR.
WARNING! Purge the fluid pressure from the system before disconnecting
any part of the system. OTHERWISE, DEATH OR PERSONAL INJURY COULD
OCCUR.
WARNING! Keep the hot-melt hoses away from walkways and the moving
parts of the hot-melt system. OTHERWISE, PERSONAL INJURY OR EQUIP-
MENT DAMAGE COULD OCCUR.
WARNING! The hot-melt unit should be installed so that it can be turned off at
a location away from the hot-melt unit.
Cautions
All personnel involved with the installation, operation, and maintenance of the equipment must read and thoroughly
understand the following cautions:
CAUTION! Never hose or steam-clean the unit. If the surrounding area is
cleaned in this manner, protect the unit by covering it with plastic or other
waterproof material. OTHERWISE, DAMAGE TO EQUIPMENT COULD OCCUR.
CAUTION! Do not bend the hot-melt hoses less than an 18-inch (460 mm)
radius. OTHERWISE, EQUIPMENT DAMAGE COULD OCCUR.
CAUTION! Place Material Safety Data Sheets for the adhesive near the unit.
OTHERWISE, DAMAGE TO EQUIPMENT COULD OCCUR.
Summary of Contents for MCP-25/MS
