J
USING YOUR HARNESS
FIGURE G
Your stroller harness is specifically designed with many
built in safety features. This includes the requirement
that, when opened, all straps are released so that no
dangerous loops can be formed causing a strangulation
hazard.
WARNING: YOUR CHILD MUST ALWAYS
BE HARNESSED WHEN IN THE STROLLER
Closing your harness:
16. Slide each of the shoulder strap bottom guides (a) into
the corresponding channel on the top of each side strap
prong.
17. Insert each completed prong into the central buckle
housing (b).
Carefully adjust the harness straps to snugly
fit your child by adjusting the sliders (c & d)
located on each strap. The harness should
be fitted to your child’s body, tight enough
so that they cannot wriggle free of the straps
but, loose enough, so as not to cause any
discomfort.
Opening your harness:
18. Press the central housing button (e).This
will release both side prongs from the central
housing. The shoulder and waist straps will
release automatically from each other.If the
shoulder and waist straps do not automatically
disengage from each other, manually slide the
guides of the waist channels. Your harness will
separate into 5 sections.
IMPORTANT WARNING: WHEN NOT IN USE, BE SURE THE
SHOULDER AND WAIST STRAPS ARE ALWAYS DISCONNECTED
FROM THE CENTRAL HOUSING AND EACH OTHER.
a
b
c
e
d
!
!
!
F
G
TO REMOVE THE SEAT
FIGURE F
13.To remove the seat: Feeling the side of the nylon
housing that sits below the frame at each side (facing
inward), locate the release button in the side housing
FIGURE G
14. Press the release button inward while simultaneously
lifting upward on the housing. Repeat for the other side
and lift the seat free from the stroller.
15. Lift the seat free from the stroller. The clip foot will
automatically disengage.
IMPORTANT WARNING: ALWAYS TEST THAT ALL BUCKLES AND
CLAMPS ARE SECURELY ENGAGED BEFORE USE.
FOLDING YOUR STROLLER
The Joey Seat for Zee Two
cannot
be folded with your
stroller. Remove the seat as outlined in Fig. F, prior to
folding your stroller.
