background image

 

 

 

 

 

 

 

 

10 947100 

It is cost effective to expand a centrally amplified 
paging system with Valcom distributed amplified 
speakers.  In many instances expanding a centrally 
amplified paging system involves replacement of the 
expensive central amplifier with a larger one in order 
to provide the additional power that the speakers or 
horns require. 
 
 
 

This also involves additional labor in re-balancing the 
system.  Adding high voltage type speakers to an 
existing amplifier where the load is not configured 
properly will cause distortion or premature system 
failure, again requiring replacement of the central 
amplifier.  By using Valcom distributed amplified 
speakers to expand the system, almost unlimited 
growth is possible, without loading down the existing 
amplifier. 
 

 

 

ADVANTAGES OF DISTRIBUTED AMPLIFIED SYSTEMS 

 

Low voltage, therefore existing telephone cable (Class 2 wiring) can be used to eliminate costly outside plant or 
indoor conduit. 

 

Low voltage operation means much less power dissipation (heat), therefore the longevity of the paging 
equipment is increased dramatically. 

 

Multizone capability of 96 zones from a single trunk port.  (Up to 576 Zones with All Call with multiple 
systems connected for Global All Call – Call Valcom Technical Support for assistance) 

 

Talkback, one-way or combination systems are easy to configure. 

 

Individual volume controls built-in to each one-way speaker for volume adjustment after system is installed. 

 

It is cost-effective to install one telephone cable versus installing both telephone cable and 70 volt shielded 
paging cable. 

 

Unlimited one-way speaker expansion since each speaker is self-amplified. 

 

Jobs requiring explosion-proof systems are easily accommodated. 

 

Amplified one-way speakers can interface 70 volt systems without changing or adding central amplifier. 

 

Many localities require conduit for "high voltage" (Class 1) conductors, this is rarely a necessity with a 
distributed amplified system. 

 

The rated output of a distributed amplified paging speaker or horn is always available due to the fact that the 
actual audio signal amplification is accomplished on an individual basis.  In a 70 volt system, the rated output is 
only available if the central amplifier is actually providing a full 70 volts to the speaker or horn and the audio 
signal line losses are negligible. 

 

Background music is unaffected in zones that are not currently being paged. 

Summary of Contents for V-1094A













Reviews: