2
947101
Power Requirements
Voltage:
-21.5 to -26 Vdc
"A" and "B" battery
Current:
"A" Battery, 50 mA*
"B" Battery, 100 mA
* ("A" Battery = filtered talk battery)
Environment
Temperature:
0 to 50 Degrees C
Humidity:
0 to 85% non-precipitating
DESIGN
General
The Valcom V-1101A One-Zone One-way Page
Adapter is designed to provide access to paging from
a standard PABX loop trunk port, an electronic key
system or 1A2 key system C. O. line button, or a 1A2
key system intercom number. In some cases, access
is also possible from a PABX or electronic key
system page port.
REMEMBER: All Valcom paging systems are made
up of three basic components: a page control unit,
speakers, and a power supply.
When one-way amplified speaker assemblies are
specified in this manual, consult your Valcom catalog
for the styles available. Once the style and quantity
of speakers is determined, select the appropriate
power supply after referring to the Valcom One-way
Paging manual or the Valcom catalog.
In addition to the parts listed in each of the following
sections, you will need a 66B type punch down block
and a 25-pair cable with a female amphenol
connector. These may be purchased from Valcom as a
unit with the cable and block already connected and
installed on a mounting frame (part # VM-101).
Electronic Key or PABX Access
When using the V-1101A with an electronic key
system or PABX, the following equipment will be
required:
•
(1) V-1101A One Zone One-way Page Adapter
•
(1) C. O. Line Card (electronic key system) or
(1) Loop Trunk Card
•
Valcom one-way amplified speaker assemblies
(quantity and style determined by specific
installation)
•
A –24 Vdc power supply (size and quantity
determined by number and style of speakers)
Operation: Press the appropriate line key (electronic
key system) or dial the appropriate trunk access code
(PABX). You will immediately be connected to the
paging speakers. Make your announcement. The
V-1101A will automatically disconnect when you
hang up.
1A2 Key Button Access
When accessing the V-1101A from a 1A2 key system
line button, the following equipment will be required:
•
(1) V-1101A One Zone One-way Page Adapter
•
Valcom one-way amplified speaker assemblies
(quantity and style determined by specific
installation)
•
A –24 Vdc power supply if the existing key
system supply is not adequate (the power
requirements are determined by number and style
of speakers)
NOTE: A C.O. line card is NOT required in this
application.
Operation: Press the appropriate line button. You
will immediately be connected to the paging speakers.
Make announcement. The V-1101A will
automatically disconnect when you hang up.
1A2 Intercom Access
When accessing the V-1101A from a bell/ buzzer
intercom connected to a 1A2 key system, the
following equipment will be required:
•
(1) V-1101A One Zone One-way Page Adapter
•
(1) Unused intercom number
•
Valcom one-way amplified speaker assemblies
(quantity and style determined by specific
installation)
•
A –24 Vdc power supply if the existing key
system supply is not adequate (power
requirements are determined by number and style
of speakers)
PABX
TRUNK
PORT
V-1101A
VALCOM
ONE-W AY
AMPLIFIED SPEAKER
ASSEMBLIES
24VDC
POWER SUPPLY
FIGURE 1 - TYPICAL PABX INSTALLATION
