4
ALCOM
V
VIP-LLE
W/BL
W/O
W/GN
W/BR
900' MAX DISTANCE
CAT 3/5/6
802.3af Compliant PoE Network Port
Paging Horn
Status
Link
Act
WHITE/BLUE
BLUE
WHITE/GREEN
GREEN
WHITE/BROWN
BROWN
WHITE/ORANGE
NOT USED
Front View
Rear View with Screw Terminal Connector
VM-186
RJ45
BROWN
BLUE
WHITE/BLUE
BLUE
WHITE/ORANGE
ORANGE
WHITE/GREEN
GREEN
WHITE/BROWN
BROWN
Note: The Brown and White/brown pair should
be twisted together and inserted into the
connector noted on the drawing and the Green
and White/Green pair should also be twisted
together and inserted into the connector that is
noted on the drawing.
Note: The screw terminals are removable.
Gently lift away from the circuit board to
remove. Make the necessary wire connections,
then replace the screw terminals over the pins
on circuit board.
There are two versions of the VIP-LLE.
Refer to the diagram below that corresponds to the version being installed.
Figure 1. (VIP-LLE versions with 8-pin screw terminal output connector.)
IP Paging Horn
AUDIO OUTPUT
Rear View with RJ-45 Connector
Figure 2. (VIP-LLE versions with RJ-45 output connector.)
If using the VM-186 or other patch panel to extend the connection between the VIP-LLE (with RJ-45 connector)
and the Paging Horn, use standard T568B wiring connections.
