3
947818
VM-186
RJ45
BLUE
ORANGE
GREEN
BROWN
BROWN
BLUE
N/O RELAY OUTPUT
AUDIO INPUT
CONTACT CLOSURE INPUT
AUDIO OUTPUT
WHITE/BLUE
BLUE
WHITE/ORANGE
ORANGE
WHITE/GREEN
GREEN
WHITE/BROWN
BROWN
Network Connection
The VIP-802A has one RJ-45 network connector
on the front panel.
Use a standard Ethernet patch cable to connect
the VIP-802A to an Ethernet switch.
Status Indicator Lights
The VIP-802A has 3 status indication lights on the
front panel:
STATUS:
Illuminates at regular intervals during
normal operation. On steady indicates unit is in
reset mode.
The network jack provides two LED indicators:
Green LED:
(Link) Indicates Ethernet connection
when illuminated.
Yellow LED:
(Activity) Indicator flashes to indicate
network activity.
Signal Connections
The VIP-802A has 3 signal connectors on the rear
panel:
1 RCA jack for AUX audio input
2 RJ-45 connectors for signal connections for
each networked channel
AUX Input
: Local audio may be input via the rear
panel RCA jack. Nominal input impedance is 600
Ohms. Connect any compatible audio source using
an RCA patch cable. Audio supplied through the
rear panel RCA jack is transformer coupled to
Audio Out channels when Audio Out is idle. This is
typically
used for background music and can be
enabled or disabled for each channel.
Rear View
Networked Channels
: Access to the networked
audio output, audio input, contact closure input and
relay closure output is provided via two rear panel
RJ-45 connectors. Provided with the VIP-802A are
two RJ-45 patch cables and two VM-186 RJ-45
Connectors. Signal connections are made by
connecting one end of a patch cable to the VIP-
802A, Port 1 or Port 2, and the other end of the
patch cable to the VM-186 connector. Access to
the signals is via screw connections or 110-style
punch down block connection on the VM-186 (see
Figure 3). Signals are present on pairs of pins, as
shown in the following chart:
Figure 3. VM-186 RJ-45 Connector
Setup
Information specific to your application will need to
be programmed into the VIP-802A using a
computer. The PC used for programming should
be connected to the same subnet as the VIP-802A.
Setup will be done using the IP Solutions Setup
Tool. Download the latest version of the free IP
Solutions Setup Tool from Valcom web site at
www.valcom.com/vipsetuptool.
TECHNICAL ASSISTANCE
When trouble is reported, verify power is being
supplied to the unit and there are no broken
connections. Check voltages for proper polarity to
the one-way amplified speakers. If a spare unit is
available, substitute a spare unit for the suspected
defective unit.
Assistance in troubleshooting is available from the
factory. Call (540) 563-2000 and press 1 for
Technical Support or via email at
support@valcom.com.
When requesting assistance, you should include
all available information. General information and
troubleshooting procedures are available on the
Valcom website at www.valcom.com.
Valcom equipment is not field repairable. Valcom,
Inc. maintains service facilities in Roanoke, VA.
Should repairs be necessary, attach a tag to the
unit clearly stating your company name, address,
phone number, contact person and the nature of
the problem. Send the unit to:
Valcom, Inc.
Repair & Return Dept.
5614 Hollins Road
Roanoke, Va. 24019-5056
Summary of Contents for VIP-802A
Page 5: ...5 947818...
