1
ISSUE 0
VL-CONF-4
FOUR PORT CONFERENCE BRIDGE
INTRODUCTION
When used with Valcom VoIP FXS and Quad
Enhanced Audio gateways, the VL-CONF-4 four
port conference bridge allows conferencing of up
to 4 POTS telephones. Two conference bridges
may be connected together allowing eight users in
conference. Applications include airport crash
systems, hospital trauma centers and
municipalities for first responders.
SPECIFICATIONS
Features
·
4 Audio Inputs
·
RJ-45 jack for audio input connections
·
Main or Expansion Slide Switch
·
Operates on 24VDC
Dimensions/Weight
·
1.75” H x 6.75" W x 9.5" D
(4.45cm H x 17.15cm W x 24.13cm D)
·
Weight: 1.75 lbs. (0.80 kg)
Nominal Power Requirements
Via back panel barrel connector:
Voltage:
24VDC
Current:
50mA
Environment
Temperature: 0 to +40° C
Humidity:
0 to 85% non-precipitating
Packing List
Qty
Item
1
VL-CONF-4
1
VSP Document
2
Mounting Brackets W/ Hardware
4
Rubber Pads
4
RJ-45 Patch Cables
INSTALLATION
Mounting
The VL-CONF-4 is designed for wall, table or rack
mounting.
Table
: Provided with the VL-CONF-4 are four
rubber pads. Peel the pads from their carrier
backing and place at the four corners of the bottom
of the unit.
Wall
: Using the template on last page of this
document, mark the location of the bracket screw
holes on the wall. Drill 5/64" pilot holes, 3/4" deep,
at each screw location and use the wood screws
provided to attach the brackets to the wall. For
surfaces other than wood, use hardware
appropriate for the surface (not included). With the
brackets securely attached to the wall, attach the
VL-CONF-4 to the brackets using the included
hardware. Figure 2 illustrates the bracket
assembly.
Rack:
Following the assembly drawing, attach the
two mounting brackets to the VL-CONF-4 unit.
Using rack screws, mount the VL-CONF-4 in an
available 1U rack slot. See Figure 1.
Summary of Contents for VL-CONF-4
Page 6: ...6 ...
